Tuxedo Sewing Patten Tails

Move: Grid and Supports - fit screen and support is not always together

On 01/15/2011 reported I move on conduct of the grid line, and that the carrier does not remain in the axle.
this unwanted behavior, I had passed on to Autodesk. Here's the answer from Autodesk, and how to isolate the problem.
The procedure works like this in Revit.

• supports are placed in the axes and remain at these stick
• carrier combined with the supports, whether they follow the supports complete, depending on the Stützenumgrenzung

The following picture shows the parameter settings shown in the supports family

Under "beams cut in the plan" is hiding the parameters. The following settings are possible:

• After Geometry: Stützenumgrenzung (boundary box) is as large as the rest
• After bounding box: Stützenumgrenzung is to a small factor larger than the geometry of the support

Let's look at this a small example. . The concrete column has a size of 30x30cm bar is cut to "geometry" is set

• shift amount 20 cm. Carrier is not in the axis shift amount
• 30cm: beam remains in the axis
• 1.Verschiebung 10cm, 2 Shift 20cm: After the 1st Shift, the carrier is not in the axis. After the 2nd However, he is back in the axis.

I hope this brief description of the facts adequately explained. One solution to this is there can not at this time. The problem can only be narrow.

Autodesk has recognized this problem but also, and is currently working on a viable solution.